A Qvniidaay magnetic screen door hangs on self-adhesive hook-and-loop tape, so installation needs no drill, no screws, and no particular talent for home improvement. Most people finish in about ten minutes. The only optional extra is a few thumbtacks for wooden frames.
Watch the video first if that's your style, then follow the steps below.
That's the whole list. One check before you start: the screen should match your door opening, not the trim around it. If you haven't picked a size yet, the magnetic screen door with middle-center opening covers standard single doors and comes in widths from 80 cm up to 180 cm for double-sided openings.
Wipe the whole mounting surface with a damp cloth and let it dry completely. Dust, grease, or moisture is the number one reason the adhesive lets go later — this tiny bit of prep does more for your install than any other step on this page.
Place the screen flat on the floor with the loop strips facing up and the top edge toward the door. Smooth it out so the magnet seams sit straight — installing a twisted screen is how you end up with gaps down the middle later.
Align the hook side of the tape with the loop strips on the top, left, and right edges of the screen, and press them together. Do not peel off the white release paper yet — the adhesive stays protected until the screen is ready to go on the frame.
Run your thumb along the full length of the seam and press firmly for a few seconds. Hook and loop needs real pressure to bond — a light pass leaves the tape half-attached, and that's what causes peeling corners later.
Peel the release paper off the top edge and stick the top of the screen to the door frame first, using the alignment markers on the screen for a level fit. Then peel the rest gradually, smoothing the screen downward along the frame as you go. Work from the top — never peel all the backing at once and try to place the whole screen in one move.
For added stability, push the included thumbtacks through the edges of the screen into the frame. Note: this only makes sense on wooden door frames, and it will leave small holes.
That's it. Walk through and the self-sealing magnetic seam closes itself behind you.
Can I remove it later without wrecking the frame? Yes — peel it off slowly from a top corner. Some adhesive residue is normal; rubbing alcohol takes most of it off. Renters do this all the time.
Why won't the middle seal completely? Almost always a twisted hem or a bent seam, not a broken magnet. Straighten the hem and let the magnets meet — that's the self-sealing design doing its job. More fixes live in our magnetic screen door FAQ.
Will it hold up to pets? The mesh is tear-resistant, not claw-proof — a dog pawing the same spot every day will eventually win. We compare the options honestly in our guide to screen doors for pets.
How do I clean it? Hand wash gentle, air dry, and keep sharp tools away from the mesh. For day-to-day dust, a vacuum with a brush attachment is all you need.
If you have any questions about installation, please contact us: